This page is dedicated to helping you navigate and use your suite's appliances, switches/buttons, controls, and more.
​
If you have any questions about how use your dryer,
how to use your remote controls, etc. This is the place to look.
If you have further questions,
please do not hesitate to contact the Front Desk.
Table of Contents
Dryer Control Panel
For your convenience, we have provided a cheat sheet to help you operate your dryer unit’s control panel.
How to use.
1 - 'POWER ON/OFF' button
2 - 'START' button
Select the START button after selecting your settings
3a - 'COURSE SELECTION' button
3b - COURSE SELECTION settings
Please note: for most guests who utilize CMFEI Lodging's weekly room cleaning, the only needed settings are:
-
NORMAL (upper left setting) - washes general, street and work clothing
-
HEAVY (lower left setting) - washes towels
4 - 'TIMER' button
5 - Timer increase and decrease buttons
​
To adjust the timer for any given setting, select the 'TIMER' button and then toggle the timer increase and decrease buttons.
​
6a - 'DEODORIZER' button
6b - 'ANTISTATIC' button
​
If 6a and/or 6b is selected the dryer will spin dry with no heat. To ensure that these settings are deselected, toggle the buttons so that they are not illuminated.
Gas System & Dryer Reset
If you experience a loss of gas, or if your dryer unit does not produce heat due to earthquakes, unforeseen events, or minor issues, you may perform a gas system reset for your suite.
How to reset.
Issues that may warrant a gas system reset
-
Dryer not producing heat
-
Stove burners or oven not working
-
Loss of hot water in bathroom
Steps:
1 - Go out into the hallway and open the utility closet. Identify your gas meter by locating the small gold-colored placard with your suite number on the upper right side of the gas meter.
2 - Cut off the gas by rotating the 'GAS VALVE' clockwise.
3 - Bleed out the residual gas remaining in your gas line. Go back into your suite, go to your kitchen stove, and press and hold one of the gas burner buttons until the stove flame goes out AND you hear a beep.
4 - Reopen your 'GAS VALVE'. Go back outside into the hallway and open the utility closet. Rotate the 'GAS VALVE' counterclockwise to its original position.
5 - Unscrew the protective cap covering the 'GAS RESET' button. Press and hold the reset button for 15 seconds. Recap the 'GAS RESET' button.
​
Note: When pushing the 'GAS RESET' button, the 'GAS RESET LIGHT' will blink in 10-second intervals until the system has completely reset itself in approximately 15 minutes.
​
6 - Until the gas system has completely reset itself, do NOT turn on the stove, the burners, or the dryer unit, and do NOT run any water.